Texas-instruments TMS320C64x DSP User Manual Page 162
- Page / 306
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Y/C Video Display Mode
4-17Video Display PortSPRU629
4.3.2 Y/C Blanking Codes
The time between the EAV and SAV code on each line represents the horizon-
tal blanking interval. During this time, the video port outputs the digital video
blanking values. These values are 10.0h for luma (Y) samples and 80.0h for
chroma (Cb/Cr) samples. These values are also output during the active line
period of vertical blanking (between SAV and EAV when V = 1), unless
replaced by VBI data. In addition, if the DVEN bit in VDCTL is 0, the blanking
values are output during the portion of active video lines that are not a part of
the displayed image.
4.3.3 Y/C Image Display
Many of the standards supported by the Y/C display mode provide for both
interlaced and progressive scan formats. For interlaced display, the display
controls are programmed identically to BT.656 mode. For progressive scan
formats, the frame size is programmed to the size of a single field and only
field 1 is used.
The Y/C display mode uses the same FIFO organization as the BT.656 display
mode and generates DMA events in the same manner.
4.3.4 Y/C FIFO Unpacking
Display data is always packed into the FIFOs in 64-bit words and must be
unpacked before being sent to the display data pipeline. The unpacking and
byte ordering is dependant upon the display data size and the device endian
mode. For little-endian operation (default), data is unpacked from right to left;
for big-endian operation, data is unpacked from left to right.
- TMS320C64x DSP 1
- Reference Guide 1
- Read This First 3
- Trademarks 4
- Contents 10
- Overview 18
- 1.1 Video Port 19
- Video Port 20
- 1-3OverviewSPRU629 20
- 1.2 Video Port FIFO 22
- 1.3 Video Port Registers 29
- 1.4 Video Port Pin Mapping 30
- 2.1 Reset Operation 35
- 2.1.3 Software Port Reset 36
- 2.1.4 Capture Channel Reset 36
- 2.1.5 Display Channel Reset 37
- 2.2 Interrupt Operation 38
- 2.3 DMA Operation 39
- DMA Operation 41
- Video Port2-8 SPRU629 41
- 2-9Video PortSPRU629 42
- Video Port2-10 SPRU629 43
- 2.3.4 DMA Interface Operation 44
- 2.4 Clocks 45
- 2.5.2 FIFO Size 46
- Table 2–8 54
- Video Capture Port 63
- 3.2 BT.656 Video Capture Mode 65
- 3.2.4 BT.656 Data Sampling 70
- 3.2.5 BT.656 FIFO Packing 71
- BT.656 Video Capture Mode 72
- 3-11Video Capture PortSPRU629 73
- 3.3 Y/C Video Capture Mode 74
- Y/C Video Capture Mode 75
- 3-13Video Capture PortSPRU629 75
- 3.3.4 Y/C FIFO Packing 76
- 3-15Video Capture PortSPRU629 77
- 3-17Video Capture PortSPRU629 79
- 3-21Video Capture PortSPRU629 83
- 3-23Video Capture PortSPRU629 85
- 3.4.4 Field Identification 86
- 3-25Video Capture PortSPRU629 87
- 3.5 Video Input Filtering 88
- 3.5.3 Scaling Operation 89
- 3.5.4 Edge Pixel Replication 91
- 3.6 Ancillary Data Capture 93
- 3.7 Raw Data Capture Mode 94
- 3.7.2 Raw Data FIFO Packing 95
- Raw Data Capture Mode 96
- 3-35Video Capture PortSPRU629 97
- Figure 3–21 98
- 3.8 TSI Capture Mode 99
- 3.8.6 Writing to the FIFO 103
- Figure 3–25. TSI FIFO Packing 103
- 3.8.7 Reading from the FIFO 104
- YDEF YDEFYDEF YDEF 105
- CbDEF CbDEFCrDEF CrDEF 105
- 3.13 Video Capture Registers 111
- Field Descriptions 113
- Video Capture Registers 127
- 3-65Video Capture PortSPRU629 127
- Video Display Port 146
- 4.1.1 Image Timing 147
- 4.1.2 Video Display Counters 150
- 4.1.3 Sync Signal Generation 152
- 4.1.4 External Sync Operation 153
- 4.1.5 Port Sync Operation 153
- 4.2 BT.656 Video Display Mode 154
- 4.2.2 Blanking Codes 157
- 4.2.3 BT.656 Image Display 157
- 4.2.4 BT.656 FIFO Unpacking 158
- BT.656 Video Display Mode 159
- 4-15Video Display PortSPRU629 160
- 4.3 Y/C Video Display Mode 161
- 4.3.2 Y/C Blanking Codes 162
- 4.3.3 Y/C Image Display 162
- 4.3.4 Y/C FIFO Unpacking 162
- Y/C Video Display Mode 163
- 4-19Video Display PortSPRU629 164
- 4.4 Video Output Filtering 166
- 4.4.3 Scaling Operation 167
- 4.4.4 Edge Pixel Replication 168
- Video Output Filtering 169
- 4.5 Ancillary Data Display 170
- 4.6 Raw Data Display Mode 170
- 4.6.2 Raw Data FIFO Unpacking 171
- Raw Data Display Mode 172
- 4-27Video Display PortSPRU629 172
- 4-29Video Display PortSPRU629 174
- 4-33Video Display PortSPRU629 178
- 4.9 Display Timing Examples 180
- Display Timing Examples 181
- 4-36 Video Display Port 181
- 4-37Video Display PortSPRU629 182
- VDTHRLD with a value of 3 184
- 4-40 Video Display Port 185
- 4-41Video Display PortSPRU629 186
- 4-43Video Display PortSPRU629 188
- 4-44 Video Display Port 189
- 4-45Video Display PortSPRU629 190
- 4-47Video Display PortSPRU629 192
- 4-49Video Display PortSPRU629 194
- 4-51Video Display PortSPRU629 196
- 4.12 Video Display Registers 197
- General Purpose I/O Operation 242
- 5.1 GPIO Registers 243
- Chapter 6 268
- 6.1 Overview 269
- 6.2 Interface 270
- 6.3 Operational Details 270
- 6.4 Enabling VIC Port 272
- 6.5 VIC Port Registers 272
- Table 6–4 273
- Appendix A 277
Related products and manuals for Hardware Texas-instruments TMS320C64x DSP
(21 pages)Micron MERIDIAN 850 NOTEBOOK MERIDIAN 850 manuali
Manuali dei proprietari e guide per l'utente per Notebook Micron MERIDIAN 850 NOTEBOOK MERIDIAN 850.
We fornisce 2 manuali pdf Micron MERIDIAN 850 NOTEBOOK MERIDIAN 850 per scaricare gratuitamente in base al tipo di documento: Guida Utente, Manuale Utente
Comments to this Manuals